Poison-spyder LED TAILLIGHTS & FLASHERS Manuel d'utilisateur télécharger pdf

INSTALLATION INSTRUCTIONS

©2009 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM

LED TAILLIGHTS & FLASHERS INSTALLATION

LED TAIL LIGHT INSTALLATION

Poison Spyder Customs 4” LED taillights

are designed to work with Poison Spyder

Crusher Corners that were specically made

for aftermarket LED taillights. They also work

with other manufacturer’s corner protectors, or

on Jeeps without any corner protectors. In all

cases, a 4-1/2” round hole must be cut into corner

protector or sheet metal to install the LED (plus

screw holes for the ange-mount style LED).

These instructions do not cover the procedure

for creating this mounting hole, it is assumed that

it is already present or you purchased Poison

Spyder Crusher Corners already made for LED

taillights.

1. Pull the factory wiring harness taillight plug

through the 4” LED hole to have room to

work.

2. Cut the factory taillight plug from the stock

taillight pigtail (between the plug and the

taillight). You will re-use the taillight side of

this plug. Leave as much wire as possible.

3. Use the information in Table 1 to make

the correct connections between the cut

wires from the factory taillight plug, and the

black and red wires in the supplied LED

pigtail harness. Whether you solder or

crimp-connect, we recommend using heat-

shrink tubing on all connections. Once the

necessary electrical connections have been

made, plug the OEM pigtail plug (now with

the LED pigtail attached) back into plug in

the Jeep’s chassis harness. Do not plug the

opposite end of the pigtail into the LED lamp

xture at this time.

4. Tape-off unused wires in the stock harness.

These will be the violet/black wire on both

sides (unless you are wiring your own,

separate back-up lights) and the green/red

wire on the passenger side, which is unused.

Stow these wires inside the wire loom or zip-

tie them securely to the harness.

5. Properly ground the white wire in the LED

pigtail harness to your Jeep’s body. The

push-in style LED’s come with a ring terminal

already connected to the white wire. With

the ange-mount style LED, you will need to

add a ring terminal to the white ground wire.

Use a sheet metal screw or self-tapping

(“tek”) screw to secure the ground. Be sure

41-04-050

4” Red 24-LED Push-In

41-04-026

4-Pin LED Flasher 97-2000 TJ

41-04-051

4” Clear 24-LED Push-In

41-04-106

5-Pin LED Flasher 01-06 TJ/LJ

41-04-010

4” Red 6-LED Flange Mount

41-04-262

2-Pin LED Flasher 76-95 CJ/YJ

1 2 3

INSTALLATION INSTRUCTIONS 1

Résumé du contenu

Page 1 - INSTALLATION INSTRUCTIONS

INSTALLATION INSTRUCTIONS©2009 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COMLED TAILLIGHTS & FLASHERS INSTALLATIONLED TAIL LIG

Page 2

INSTALLATION INSTRUCTIONS©2009 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COMPoison Spyder Customs • LED TAILLIGHTS & FLASHERS

Page 3

INSTALLATION INSTRUCTIONS©2009 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COMFailure to contact us prior to having warranty work pr

Commentaires sur ces manuels

Pas de commentaire