©2010 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM
INSTALLATION INSTRUCTIONS
Thank you for purchasing a Poison Spyder Tramp
Stamp for your Jeep YJ, TJ or LJ. The Tramp
Stamp installs over the body sheet metal below
the tailgate, nishing off your Poison Spyder
body armor in style. Installation is fairly simple
with the right tools and good mechanical abilities.
If you are not condent in your mechanical skills,
please seek the help of a professional to perform
the installation. Please read through these entire
instructions before proceeding with installation.
PARTS LIST
Please check your packages immediately upon
arrival to ensure that everything listed is included,
and to check for damage during shipping. If
anything is missing or damaged, call Poison
Spyder at (951) 849-5911 as soon as possible.
(1) TrampStamp
(8) 3/16”Trussheadpoprivet,black
TOOLS NEEDED
• 3/16”transferpunchorne-tipmarker
• 13/64”drillbitanddrillmotor
• Poprivetinstalltool
• Touch-uppaintorclearcoat
INSTALLATION PROCEDURE
1. Parkvehicleonalevelsurfaceandsetthe
emergency brake. Remove any stickers,
brackets, license plate holder or any other
obstructionfromtheareabelowthetailgate
where the Tramp Stamp will be installed.
Clean the area, straighten any bends or
creases in the sheet metal, and sand/
primer/paint any bare metal to prevent rust
underneaththeTrampStamp.
2. Prep the Tramp Stamp for installation by
painting, powder coating, polishing it or
leavingitbare.TheTramp Stamp is made
of aluminum plate, so it won’t rust but it
will oxidize slightly over time if left bare or
polished.Ifyoupaintit,thoroughlycleanand
lightlyscuffwithasanderpriortoapplyingan
initialcoat ofprimer, followedby yourpaint
colorofchoice.
3. Hold the Tramp Stamp in place over the
rectangular sheet metal section below the
tailgate.Thereissomeroomforadjustment,
so make sure the gaps at either side and
alongthetopareallevenwhileholdingthe
TrampStampinplace.
4. Use the transfer punch or ne-tip marker
tomarkthe8holelocationsusingtheTramp
Stamp itself as the template, then set the
TrampStampaside.
5. Drill each of the marked hole locations
with a 13/64” bit. Be careful not to let the
bit“catch”anddeformthesheetmetalasit
breaksthrough.
6. Clear any burrs from the holes, then use
sometouch-uppaintorclearcoattoprotect
thebaremetalaroundtheedgesoftheholes
fromfuturerust.
7. PlacetheTramp Stampback intoposition
and use your pop rivet tool to install the
supplied rivets through the 8 holes. Make
suretheTrampStampislevelandcentered,
andbeginbyinstallingrivetsontwoopposite
corners to securely hold the Tramp Stamp
whileyouinstalltheremainingrivets.
Congratulations, you have completed the
installation of your Poison Spyder Tramp Stamp!
TRAMP STAMP INSTALL INSTRUCTIONS
Commentaires sur ces manuels