Poison-spyder YJ FULL CAGE KIT Manuel d'utilisateur Page 3

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 5
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 2
INSTALLATION INSTRUCTIONS
Poison Spyder Customs •
YJ FULL CAGE KIT INSTALL
Page 3
©2010 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM
openingon eitherside. Re-use the factory
hardware.
11.Install the C-Pillar Mount Plates L&R
9
wherethefactoryrollbarboltedinattherear
corners.Orienttheplateswiththerounded
point edge facing the rear of the Jeep.
SecurethemusingtheOEhardware.
FIGURE 4
7. Install the Main Side Hoops L&R
5
, one
sideatatime.HaveafriendholdtheMain
SideHoopinplacewiththe front portionof
thetubecenteredon the topatsurfaceof
theLowerA-Pillar.Holdtherearwardendof
thetubesothatitlandscenteredwithinthe
curved-pointareaoftheC-PillarMountPlate.
Tack-weldtheMainSideHoopateachend.
8. InstalltheB-Crossbar
11
betweenthetwo
Main Side Hoops. Reference the laser-
etched markings to correctly locate the
C-Crossbar along the inner side of each
MainSideHoop. Tack the B-Crossbarinto
place.
FIGURE 8
9. Install the B-Pillars L&R
14
between the
B-PillarMountPlateandtheMainSideHoop
on either side. Reference the laser-etched
markingstocorrectlylocatetheB-Pillartube
alongtheMainSideHoop.TacktheB-Pillar
intoplace.
FIGURE 9
10.InstalltheA-Crossbar
13
andtheForward
Stringers L&R
11
at the same time. Have
a friend help with holding the three pieces
in place. Start by holding the A-Crossbar
inplacebetweenthetwoMainSideHoops,
towardthefrontoftheJeep.Next,holdthe
twoForwardStringersinplacebetweenthe
A-Crossbar and the B-Crossbar. Use the
laser-etchedmarksoneach ofthetubesto
properlylocatethetube junctions.Usethe
Forward Stringers to locate theA-Crossbar
the proper distance forward from the
B-Crossbar. While holding them in place
correctly located, tack the A-Crossbar and
ForwardStringersintoplace.
FIGURE 10
11.InstalltheC-Hoop
6
andtheC-PillarsL&R
16
at the same time. Have a friend help
withholdingthethreepiecesinplace.Start
by holding the C-Hoop in place, extended
rearwardfromthedownwardbendoneach
MainSideHoop.Next,holdthetwoC-Pillars
inplaceverticallybetweenthe C-Hoop and
thelowerendsoftheMainSideHoop.While
UPDATED PHOTOS
COMING SOON!
UPDATED PHOTOS
COMING SOON!
UPDATED PHOTOS
COMING SOON!
Vue de la page 2
1 2 3 4 5

Commentaires sur ces manuels

Pas de commentaire