INSTALLATION INSTRUCTIONS
©2010 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM
CJ-YJ-TJ-LJ ROCKBRAWLER BFH FRONT BUMPER
The Poison Spyder Customs RockBrawler BFH
front bumper is easy to install with the right
tools and good mechanical abilities. If you are
not condent in your mechanical skills, please
seek the help of a professional to perform the
installation. Please read through these entire
instructions before proceeding with installation.
PARTS LIST
(1) RockBrawlerBFHBumper
TOOLS NEEDED
• TorxT55socket
• Ratchet
• Torquewrench
• Measuringtape
• Softdeadblowhammerormallet
• Fine-tip felt marker, 1/2” drill bit and drill
motor(CJmodelsonly)
BEFORE YOU BEGIN
ThePoisonSpyderCustomsFrontStingercomes
asun-painted,baresteel.Youwillwanttoeither
powdercoatorpaintthebumperpriortoinstall.If
paintingyourself,carefulpreparationwillmakea
bigdifferenceinthequalityandlongevityofyour
paintjob,evenusing“rattlecan”aerosolpaints.
Begin by thoroughly cleaning the Stinger with
solventordegreaser,thenmakesureallresidue
isremoved.Evenifyouusecheappaint,tryto
useagoodqualityprimer.“Etching”primersare
besttouseonbare,un-paintedmetal.Allowitto
properlydrybeforepaitning,andbetweenpaint
coats.
INSTALLATION PROCEDURE
1. Park the Jeep on a at,level surface and
settheparkingbrake.
2. Removeexistingfrontbumper.Ifitisstill
the OEM bumper and hardware, there are
four bolts (two on the top and two on the
bottomthatholdthebumperinplace).These
willlikelybeTorxbolts,useaT55Torxbit.
3. PlacetheRockBrawlerBFHBumperonto
theframe rails,in placeof thebumperthat
was removed. Visually align the bumper
mounting slots with the threaded holes in
the frame rails. Take measurements to
ensure that the bumper is installed square
to the frame and grill. Use a soft dead-
blow hammer, if necessary, to make ne
adjustments.
4. OnCJmodels,useane-tipfeltmarkerto
mark throughthe rearward winch mounting
holes (closest to the grille) onto the
crossmemberunderneath.Pullthebumper
off and drill the two marks with a 1/2” drill.
Later, when installing the winch, the two
rearward bolts will sandwich the bumper
betweenthecrossmemberandthewinch.If
notinstallingawinch,usetwo3/8-16X1Gr8
HexHeadCapScrewswithatwashersand
locknuts(notprovided)tosecurethebumper
tothecrossmemberatthesetwolocations.
5. Use the original hardware to bolt the
bumper to the frame rails. Torque to OE
specications.
6. If installing a winch with Poison Spyder
WinchFairleadMount,followtheinstructions
includedwiththeWinchFairleadMount.
Congratulations, you have installed your Poison
Spyder Customs RockBrawler BFH front bumper!
Commentaires sur ces manuels