Poison-spyder 3/4 LED MARKER LAMP Manuel d'utilisateur télécharger pdf

INSTALLATION INSTRUCTIONS

©2013 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM

3/4” LED MARKER LAMP INSTALL NOTES

This high quality DOT-approved LED lamp

is designed to provide years of trouble-free

performance.

PARTS LIST

Please check your packages immediately upon

arrival to ensure that everything listed is included,

and to check for damage during shipping. If

anything is missing or damaged, call Poison

Spyder at (951) 849-5911 as soon as possible.

(1) 3/4” LED Marker Lamp with Pigtail

(1) Rubber Grommet

INSTALLATION NOTES

1. This item is not a direct “plug and play” item.

Installation requires a basic understanding

and skillset of automotive wiring. The installer

may need to use a test light or multimeter

to identify the correct wires in the vehicle’s

wiring harness to tap into in order to power

this lamp. If this is beyond your skills, please

seek the help of someone more experienced

with automotive wiring.

2. On the 2-Wire version, there are two wires

on the lamp pigtail. The BLACK wire is

POSITIVE. The WHITE wire is NEGATIVE.

Be sure to make your connections

appropriately. The 2-wire LED may be used

as either a marker lamp (running light) or as

a turn signal, but not as both simultaneously.

3. On the 3-Wire version, there are three

wires on the lamp pigtail. The BLACK wire is

POSITIVE for the marker lamp function. The

RED wire is POSITIVE for the turn signal

function. The WHITE wire is NEGATIVE, or

ground. Be sure to make your connections

appropriately. The 3-wire LED may be used

as both a marker lamp and a turn signal

simultaneously.

4. We recommend using female bullet

connectors (not included) to connect to the

male bullet connectors already existing on

the pigtail (2-wire version only). Alternatively

you may cut the existing bullet connectors

off of the pigtail to use the connector type

of your choice. The 3-wire version does not

come with pre-installed connectors so you

will have to supply and use connectors of

your choice.

5. DO NOT cut off the fat “pill” section of the

pigtail (3-wire version only). The components

housed inside it are necessary for proper

function of the LED lamp.

6. Many Poison Spyder products such as

Crusher Flares™ and DeFenders™ come

with a 3/4” mounting hole already cut into

them, intended for mounting this lamp.

7. If installing into a blank panel or location

without an existing hole, use a 3/4” hole

saw, step drill, or Greenlee punch to create a

suitable hole.

8. Installing the lamp into the 3/4” hole is

easiest by rst slipping the pigtail through the

grommet, then through the hole. Next, push

the grommet into place in the hole, followed

by pushing the lamp into the grommet. A

small amount of soapy water may help

lubricate the components during installation.

2-Wire 3/4” LED Lamp

3-Wire 3/4” LED Lamp

1 2

INSTALLATION INSTRUCTIONS 1

Résumé du contenu

Page 1 - INSTALLATION INSTRUCTIONS

INSTALLATION INSTRUCTIONS©2013 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM3/4” LED MARKER LAMP INSTALL NOTESThis high quality DO

Page 2

INSTALLATION INSTRUCTIONS©2013 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COMPoison Spyder Customs • 3/4” LED MARKER LAMP INSTALL N

Commentaires sur ces manuels

Pas de commentaire